Rigid tool system

Reduce tool inventory Tooling is cheaper than grinding wheels and takes up less physical space. In addition, hard turning provides easier chip control and faster removal of metal It greatly reduces the installation time, reduces the operation, and reduces the cycle time The chart below illustrates a typical part of the processing operation, and dramatically […]


Pay attention to the cutting direction. The geometry of the windshield wiper is designed to track the appropriate chip flow and surface quality behind the cutting edge. In the face of operation, it should always operate with a larger diameter. Distortion can occur in radius, chamfer and cone, because of the trailing edge. Advantages of […]

high-performance PHCD

The following theory can be deduced: “the bigger the particle, the better the anti-wear.” However, this reduces the quality, sharpness and sharpness of cutting edges without considering the manufacturing process of cutting edges. The percentage volume fraction of the metal binding phase also increased and had a negative effect. The loudspeaker high-performance PHCD consists of […]


The wear resistance of CHVD – d is significantly higher than that of PHCD. The reason for this is that it has no metal shackles, and its diamond composition is almost 100%. Individual, single grain diamond particles deposited in the gas, common growth, so that they cannot be separated into a solid, polymerized diamond layer. […]

cutting material

The main difference between polycrystalline diamond cutting materials, PHCD and chvd-d is how they are made and their structure. PHCD describes a cutting material group, where diamond is burned into particles in metal matrix. Every grain is a single crystal. Because of the change of grain, different properties are produced. Chvd-d (chemical vapor deposition) is […]

tool holders

Static balance applies to tool holders = there is less than 20,000 running speed. (A) the length (A) is less than twice the diameter (D2) Dynamic balance applies to tool holders = running speed over 20,000 R.P.M. Length (A) is more than twice the diameter (D2) All single tool drilling and drilling tools should be […]

tool system

Explanation: the speed is 9500 r.p. M and 1 kg of weight G2.5 means that the axis of rotation axis of the center of gravity is allowed to be offset by 2.5 mu m. The speed of 19,000 R.P.M. is 1.25 mu m and mu m 0.625 38000 R.P.P.M. If the weight of the tool […]


The consequences Vibration caused by centrifugal force. These reasons: = main shaft bearing is damaged = mediocre surface quality = low precision = reduce tool life = noise Ask for The best working conditions must be balanced. = surface quality = production accuracy Life = tool operation = or prescribed by machine tools Manufacturer (warranty […]

milling cutter

The results. The basic features of these calculations can be found in the following pages. Select the shortest clamping fixture and the milling cutter bar to control the operation tolerance of the tool. Large cut width and long suspension reTuire Vpeci, in cutting width to achieve the best cutting effect, because of reducing cutting force. […]

Angle mills

Other additives such as copper paste are not allowed. This will have a negative impact and will produce a clamping force. All clamping screws have been coated with additives. The milling direction Most Angle mills are correct and recommend using them with crawling milling because this is generally recommended as a hard alloy tool. The […]